About The Setup Wizard - Dell PowerVault ML6010 Troubleshooting Manual

Configuring Your Library
Back to Contents Page
Configuring Your Library: Dell™ PowerVault™ ML6000
Tape Library User's Guide

About the Setup Wizard

Using the Setup Wizard
Logging On to the Web Client
Managing the Network
Working With Partitions
Configuring Cleaning Slots
Configuring I/E Station Slots
Setting Tape Drive Parameters
Working With Control Paths
Obtaining and Installing a License Key
Setting Customer Contact Information
Configuring the Library E-mail Account
Working With RAS E-mail Notifications
Working With User Accounts
Setting the Date, Time, and Time Zone
Working With FC I/O Blades
Configuring Library Security Settings
Configuring the Internal Network
Configuring System Settings
Configuring Operator Panel Display Settings
Once you have installed the hardware as described in
your library's settings. A Setup Wizard helps you get started configuring your library, and menu commands on both the
operator panel and the Web client allow you to reconfigure your library at any time.
Caution:
Always save the library configuration after modifying configurable items. This will allow you to restore the
most current settings if necessary. See
About the Setup Wizard
When you first power on the library, the operator panel displays the Setup Wizard, which walks you through the initial
configuration of the library's basic operational settings.
The Setup Wizard on the operator panel only runs once, at initial startup. After that, administrators access the Setup Wizard
any time via the Web client or use commands on the Setup and Operations menus to modify all library settings, including
network settings. See Completing the Library Configuration With Menu
While completing the Setup Wizard at initial startup is recommended, you may need to begin using the library locally
immediately. In this case, you can cancel out of the Setup Wizard and allow the library to run on the default configuration
settings. See Default Configuration
For additional information, see
Using the Default Administrator Account
When you power on the library for the first time, you do not need to log in to use the operator panel. You can start using the
Setup Wizard immediately. After the initial setup session on the operator panel, however, you will need to log in to the
operator panel as well as the Web client.
file:///T|/htdocs/stor-sys/ML6000/en/html/ch04.htm[9/17/2012 1:49:29 PM]
Setting Up the PowerVault ML6000
Saving and Restoring the Library
Settings.
Using the Setup Wizard.
Library, you are ready to configure
Configuration.
Commands.