Run The Configuration Wizard; Configuring The Network - Dell EMC Data Domain DD9800 Installation Manual

The customer can later enter the following to redisplay the EULA and accept it:
system show eula

Run the configuration wizard

The CLI configuration wizard starts automatically the first time the system boots. The wizard prompts you through a series of
questions that provide just enough information for initial system configuration and basic network connectivity.
NOTE: You can initiate the CLI configuration wizard manually by entering the config setup command.

Configuring the network

Steps
1. Enter yes to configure the system for network connectivity.
Network Configuration
Configure Network at this time (yes|no) [no]:
yes
2. Enter yes to configure DHCP (Dynamic Host Configuration Protocol) to obtain network parameters (such as, the host
name, domain name, and IP addresses) dynamically from a DHCP server. Or enter no to configure the parameters manually.
Use DHCP
Use DHCP for hostname, domainname, default gateway
and DNS servers? (At least one interface needs to
be configured using DHCP)
3. Enter a fully qualified domain name (FQDN) for the host name; for example, str01.yourcompany.com. Or accept the
host name, if the system was able to discover it.
Enter the hostname for this system
(fully-qualified domain name)[]:
4. Enter the DNS (Domain Name System) domain name; for example, yourcompany.com. Or accept the domain name, if the
system was able to discover it.
Domainname
Enter your DNS domainname []:
5. Enable and configure each Ethernet interface. Accept or decline DHCP for each interface. If the port does not use DHCP to
discover network parameters automatically, enter the information manually.
Ethernet port eth0a
Enable Ethernet port eth0a (yes|no|?) [yes]:
no
Ethernet port eth0b
Enable Ethernet port eth0b (yes|no|?) [no]:
yes
Use DHCP on Ethernet port eth0b (yes|no|?) [no]:
Enter the IP address for eth0b [192.168.10.185]:
Enter the netmask for eth0b [255.255.255.0]:
6. Enter the IP address of the default routing gateway. Or accept the default gateway, if the system was able to discover it.
Default Gateway
Enter the default gateway IP address:
192.168.10.1
7. Enter the IPv6 address of the default routing gateway or accept the IPv6 address of the default gateway if the system was
able to discover it. If IPv6 is not in use, leave the field empty, and press Enter to continue.
IPV6 Default Gateway
Enter the ipv6 default gateway IP address:
(yes|no|?)
Configure System for Use 83