Table of Contents
Advertisement
Configuring Your Library
The library ships with a default administrator account. The user name on the account is admin and the password is
password. When you see the Login screen on the operator panel or Web client, type admin in the User Name text box and
password in the Password text box. As soon as the initial setup is complete, you should change the password on the default
administrator account. For information on changing passwords, see
Note:
You cannot delete the default administrator account or modify the user name. You can, however, change the
password.
Note:
If you misplace the password for the default administrator account, contact Dell Technical Support (see
Contacting
Dell).
Completing the Library Configuration With Menu Commands
The Setup Wizard is an aid to assist you with the initial configuration of the library. The Setup Wizard, however, contains only
a subset of configuration tasks. The operator panel tabs and Web client menus provide access to all configuration options that
are included in the Setup Wizard and many that are not. Once the initial Setup Wizard session is complete, administrators can
choose whichever method is most convenient or necessary for modifying library settings.
The following topics cover using the Setup Wizard as well as Setup and Operations commands to configure the library. Paths
to open the appropriate screens on both the operator panel and the Web client are given for each task. For the operator
panel, the paths refer to the navigation tabs at the top of the home page. For the Web client, the paths refer to the menus.
For the menu trees on both the operator panel and Web client, see
Note:
Power cycling (powering the library on and off) is not necessary to configure the library.
Using the Setup Wizard
The Setup Wizard simplifies the process of configuring the library. When you first power on the library, the operator panel
displays the Setup Wizard. After that, you can no longer access the Setup Wizard from the operator panel. You can always
access the Setup Wizard from the Setup menu on the Web client.
The recommended procedure for using the Setup Wizard for the initial configuration is as follows:
1
Turn on the library and begin using the Setup Wizard on the operator panel.
2
Work through all of the screens as prompted (see
3
When you get to the network configuration screens, configure the network settings as follows:
Note:
You cannot log into the Web client until you have configured the network settings.
•
If you are using IPv4: On the Setup Wizard: Enable IPv6 screen, do NOT select the Enable IPv6 checkbox.
Click Next. Configure the network settings.
•
If you are using IPv6: On the Setup Wizard: Enable IPv6 screen, select the Enable IPv6 checkbox and click
Next. You have enabled IPv6 but you will not be prompted to configure IPv6 settings here. Continue with the
Setup Wizard screens. Then, when you are finished using the Setup Wizard, configure the IPv6 network settings
by going to Setup > Network Mgmt on the operator panel.
4
Log out of the operator panel.
5
Using the default administrator account, log in to the Web client. Type admin in the User Name text box and
password in the Password text box.
6
Complete the Setup Wizard screens on the Web client interface. The final Setup Wizard screen will prompt you to
apply your settings.
When you have completed the Setup Wizard, the Library Configuration report appears on the Web client. The Library
Configuration report provides information on the library's tape drives, partitions, I/E stations, storage slots, cleaning
slots, and loaded media. See
report.
Note:
Depending on the size of the library, there may be a slight delay after you apply the settings in the Setup
Wizard while the Library Configuration report page loads.
file:///T|/htdocs/stor-sys/ML6000/en/html/ch04.htm[9/17/2012 1:49:29 PM]
Setup Wizard
Viewing the Library Configuration
Modifying Local User
Accounts.
Menu
Trees.
Tasks).
for more information on the Library Configuration
Hide quick links:
Advertisement
Table of Contents
