Table of Contents
Advertisement
Setting Up the PowerVault ML6000 Library
more information on bulk loading, see
see
Configuring Your
•
When configuring network settings for the Default Gateway, you must enter a valid IP address. The library will not
accept a blank value or 0.0.0.0.
•
Before updating library firmware, be sure to save the library configuration. For instructions, see
the Library
Configuration.
•
When drive topology changes are made, the library state may need updating before the partition can be used. To
update the library state, perform one of the following actions:
•
Change the partition state to offline and change the state back to online.
•
Open the library door and close the door 10 seconds later.
•
Remove the drive from the rear of the library and insert the drive 1 minute later.
•
Reboot the library.
CAUTION:
Please check your host backup software documentation for driver requirements. If Windows drivers are
required, either the Windows default driver may be used (recommended), or the PowerVault ML6000 device-specific
device driver can be found at http://support.dell.com. To avoid a possible performance reduction in a SAN
environment, please consult Microsoft Knowledge Base article 842411 when using device-specific drivers.
Back to Contents Page
file:///T|/htdocs/stor-sys/ML6000/en/html/ch01.htm[9/17/2012 1:49:11 PM]
Running Your Library
Library.
For more details regarding configuring I/E station slots,
Saving and Restoring
Hide quick links:
Advertisement
Table of Contents
