Dell PowerVault ML6010 Troubleshooting Manual page 139

Installing, Removing, and Replacing
8
If a partition references tape drives within the module you are removing or replacing, modify any affected partition by
removing the referenced drive elements from the partition. See
For example, in
was deleted, as well as its drive references in the 9U Library Expansion Module. Library_a and Library_b still require
partition modifications to remove the drive reference and hereby free the 9U Library Expansion Module of all partition
resource references.
9
If you are removing or replacing a 9U Library Expansion Module, set the number of I/E station slots to six. You can
reconfigure I/E station slots after the module removal or replacement is complete. See
10
Power off the library.
11
Disconnect all power cords, network data cables, and module-to-module cables from each module you will be
removing.
Note:
You should label all cables before you remove them so you can later reconnect them to their proper
locations.
12
Park the robot assembly in the 5U Library Control Module. Before unstacking the library, the robot assembly must be
placed in the 5U Library Control Module.
a
Open the I/E station and access doors of each module.
b
Using your hands, gently lift the robot assembly into the 5U Library Control Module. The robot assembly should
glide slowly and with some resistance.
Caution:
Support the robot assembly by holding onto the broad metal X-axis plate. Lifting the robot by the thin
metal rod will bend the rod. Lifting the robot by the black plastic picker body can damage the robot.
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
Figure 18, all partitions reference drives in the 9U Library Expansion Modules. In
Modifying Partitions.
Configuring I/E Station
Figure 19, Library_c
Slots.