Replacing The 9U Expansion Module - Dell PowerVault ML6010 Troubleshooting Manual

Installing, Removing, and Replacing
plate.

Replacing the 9U Expansion Module

1
Remove all tape drives from the 9U Library Expansion Module that you are adding. See
Replacing Tape Drives
2
Remove the power supplies from the 9U Library Expansion Module that you are adding. See
Replacing Power Supplies
3
Open the 9U Library Expansion Module's access door and raise the guide pin by pulling it up and turning it slightly as
if it were a screw. Otherwise, the guide pin may scratch the front doors of the module on which you are stacking it.
1 Guide pin
2 Thumbscrew
4
Lift the new 9U Library Expansion Module and, from the front of the library, place it in the desired location.
5
Fasten the module to the rack with rack ears.
6
Secure the two modules together by tightening the two thumbscrews at the base of the front of the module and the
two thumbscrews located at the base of the back of the module. Then lower the module's guide pin (located at the
base of the front of the module) by turning it and pushing it down.
7
Tighten all thumbscrews located at the base of the front and back of the modules.
8
Engage the Y-rails of each module in your library configuration. Ensure that the Y-rails are properly aligned and the
thumbscrews are tightened.
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
for instructions on removing tape drives.
for instructions on removing power supplies.
Adding, Removing, and
Adding, Removing, and