Dell PowerVault ML6010 Troubleshooting Manual page 140

Installing, Removing, and Replacing
c
After raising the robot assembly to the approximate middle of the 5U Library Control Module, hold it in place with
one hand and, using your other hand, move the parking tab in a counter-clockwise direction until it stops in the
"parked" position. The metal parking tab is located at the bottom of column 1.
d
Gently lower the robot assembly to rest on the parking tab.
1 Parking tab in "parked" position
13
Remove all power supplies from each module that you intend to remove. For details, see
Replacing Power
14
Remove all tape drives from each module that you intend to remove. If you are going to replace the module, label the
drives with their locations so you can re-install them in the same locations later. For details, see
and Replacing Tape
15
If the module you are removing or replacing contains FC I/O blades, remove both the I/O blades and the
accompanying fan blades from the 9U Library Expansion Module. For details, see
I/O Blades and Adding, Removing, and Replacing the FC I/O Fan
16
Before removing a module, you must first remove all 9U Library Expansion Modules (if any) positioned above it.
Disconnect all power cords, network data cables, and module-to-module cables from the module you are removing or
replacing and all modules located above it. Then remove the modules.
Warning:
weighs approximately 60 lbs (27.2 kg). A 9U Library Expansion Module, without tape drives, tape
cartridges, or power supplies, exceeds 65 lbs (29.5 kg).
To avoid serious injury, at least two people are required to safely lift the modules.
Note:
If the library is installed in a rack, you need to perform additional steps to remove modules from and
place modules into the rack. See
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
Supplies.
Drives.
Without tape drives, tape cartridges, or power supplies, a 5U Library Control Module
Installing the Library in a Rack
Adding, Removing, and
Adding, Removing, and Replacing FC
Blade.
for more information.
Adding, Removing,