Preparing To Remove Or Replace A Module - Dell PowerVault ML6010 Troubleshooting Manual

Installing, Removing, and Replacing
1 Parking tab in "unparked" position
6
Connect all power cords, network data cables, and module-to-module cables. Make sure the module terminators are
installed at the top and bottom of the stack of modules. For cabling instructions, see
7
Power on the library.
8
Reconfigure the library, including applying the new COD license key, using the operator panel or Web client.
9
Add the tape cartridges to the library's modules using the I/E station commands from the operator panel or Web
client.
10
Open the host application and reinventory in order to synchronize its logical inventory with the physical inventory of
the library.

Preparing to Remove or Replace a Module

Follow the instructions in this section before performing any of the following procedures:
• Permanently Removing 9U Library Expansion Modules From an Existing Library
• Replacing the 5U Library Control Module
• Replacing a 9U Library Expansion Module
Note:
If a 5U Library Control Module is replaced, all library configuration data will be invalidated and requires a
new library configuration. Follow the instructions below to completely export all tape cartridges and completely delete
all logical partition configuration and cleaning slot assignments.
Note:
If one or more 9U Library Expansion Modules are removed or replaced, follow the steps below to modify
or delete only the affected partition configuration and cleaning slot assignments.
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
Cabling the Library.