Table of Contents
Advertisement
Installing, Removing, and Replacing
1
Parking tab in "parked" position
6
Remove all power supplies from each module.
7
Remove all tape drives from each module.
Unstacking the Existing Modules
Unstack the modules as follows:
1
Starting with the topmost module of your library, open the I/E station and access doors.
Caution:
Before unstacking the modules, the robot assembly must be parked as described in
Install an Additional 9U Library Expansion Module
2
If your current configuration already uses a 9U Library Expansion Module, disengage the Y-rails so the modules can be
safely unstacked.
a
From the front of the library, find the Y-rail release mechanism, which is located on the left side of the module.
Squeeze the handle of the Y-rail release mechanism, lift it, and release it so that it locks into place.
b
From the rear of the library, find the rear Y-rail release mechanism located in the interior of the right side of the
module. Squeeze the handle of the Y-rail release mechanism, lift it, and release it so that it locks into place.
Note:
The rear Y-rail is impossible to lift up with the tape drives installed.
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
above.
Preparing to
Hide quick links:
Advertisement
Table of Contents
