Installation - NEC Express5800/120Rg-1 User Manual

9-46 Upgrading Your Server

Installation

Take the following steps to install a PCI board on the riser card:
IMPORTANT:
"insulator (black)" to protect PCI boards. Do not remove the insulator,
and handle it carefully. The insulator is not shown in the figures in this
manual for simplifying the illustrations.
NOTES:
Each riser card supports low-profile or full-height PCI boards.
Before installing a PCI board, confirm that the type of the PCI
board.
When installing a PCI board, confirm that the card connector
matches the connector of the riser card.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Remove the logic cover.
4.
Grasp a handle on the riser module assembly and lift straight up and remove the riser
module assembly from the server.
The full-height riser card is equipped with an