Table of Contents
Advertisement
4-14 Configuring Your Server
Option
Set User
Password
Password on boot
Fixed disk boot
sector
Power Switch
Inhibit
Parameter
Up to eight
alphanumerics
[Disabled]
Enabled
[Normal]
Write Protect
[Disabled]
Enabled
Description
Supervisor password controls access
to the setup utility.
When Enter is pressed, the user is
prompted for a password; press Esc
to abort. Once set, this can be
disabled by setting it to a null string, or
by clearing password jumper on
system board (refer to Configuring
Mother Board Jumpers in this
chapter).
Disables or enables password entry
on boot.
Will write protect the boot sector of the
hard drive to prevent viruses from
corrupting the drive under DOS if set
to write protect.
Enables or disables the POWER
switch. If "Enabled" is selected,
power-off with the POWER switch
becomes unavailable after OS
boot-up. (Forced shut down feature is
always acceptable to the server.
Forced shut down is a feature to shut
down by pressing the POWER switch
for at least four seconds.)
Your Setting
[
]: Factory-set
Advertisement
Table of Contents
Troubleshooting
