NEC Express5800/120Rg-1 User Manual page 168

6-10 Installing and Using Utilities
Starting
The following two methods are available to start the server.
Running NEC EXPRESSBUILDER from the management PC via LAN
Running NEC EXPRESSBUILDER from the management PC via direct connection
(COM B)
For the procedure for starting NEC EXPRESSBUILDER for DOS-based with Remote Console, see
"NEC DianaScope".
IMPORTANT:
Do not change the boot device order in BOOT menu in BIOS
SETUP. NEC EXPRESSBUILDER cannot be used if the
DVD-ROM drive is not the first device to launch the system.
To use this feature, you need to create a configuration file
(3.5-inch floppy disk) that includes communication method
between the server and the management PC, and various setup
parameters. Use NEC DianaScope or run "System Management"
menu from NEC EXPRESSBUILDER to create a configuration
file. Save the configuration file into the root directory of the floppy
disk as the following file name.
- File name: CSL_LESS.cfg
NOTE: The following items of BIOS setup information will be set as
shown below.
LAN Controller:
Serial Port A:
Base I/O Address:
Interrupt:
Serial Port B:
Base I/O Address:
Interrupt:
BIOS Redirection Port:
Baud Rate:
Flow Control:
Console Type:
[Enabled]
[Enabled]
[3F8]
[IRQ 4]
[Enabled]
[2F8]
[IRQ 3]
[Serial B]
[19.2K]
[CTS/RTS]
[PC ANSI]