NEC Express5800/120Rg-1 User Manual page 203

Error
Error message
code
8100 Memory Error detected in DIMM group #1.
8101 Memory Error detected in DIMM group #2.
8102 Memory Error detected in DIMM group #3.
8103 Memory Error detected in DIMM group #4.
8104 Memory Error detected in DIMM group #5.
8105 Memory Error detected in DIMM group #6.
8160 Mismatch Processor speed detected on
Processor 1.
8161 Mismatch Processor speed detected on
Processor 2.
0B80 BMC Memory Test Failed.
BMC Firmware Code Area CRC check
0B81
failed.
0B82 BMC core Hardware failure.
0B83 BMC 1BF or 0BF check failed.
0B8A BMC SEL area full
0B8B BMC progress check timeout.
0B8C BMC command access failed.
0B8D Could not redirect the console - BMC Busy -
0B8E Could not redirect the console - BMC Error -
0B8F Could not redirect the console - BMC
Parameter Error -
0B90 BMC Platform Information Area corrupted.
0B91 BMC update firmware corrupted.
0B92 Internal Use Area of BMC FRU corrupted.
0B93 BMC SDR Repository empty.
0B94 IPMB signal lines do not respond.
0B95 BMC FRU device failure.
0B96 BMC SDR Repository failure.
0B97 BMC SEL device failure.
0B98 BMC RAM test error.
0B99 BMC Fatal hardware error.
0B9A Management controller not responding.
Troubleshooting 8-7
Recommended Action
Contact your service representative to
replace the DIMM in the relevant group.
Contact your service representative.
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
Clear the system event logs by using the
BIOS SETUP utility (see Chapter 4).
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
This is not a fatal error. Turn off the power
once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
Turn off the power once and then on again
to restart the server. If the error cannot be
corrected, contact your service
representative.
This is not a fatal error. Turn off the power
once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
This is not a fatal error. Turn off the power
once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
Update the RMC firmware. If the error
cannot be corrected, contact your service
representative.