Nec Expressbuilder For Dos-Based With Remote Console - NEC Express5800/120Rg-1 User Manual

Nec servers user's guide
Hide thumbs Also See for Express5800/120Rg-1:
Table of Contents

Advertisement

NEC EXPRESSBUILDER for DOS-based with Remote Console

This subsection describes the procedures for using NEC EXPRESSBUILDER for DOS-based with
remote console.
NEC EXPRESSBUILDER contains the remote console feature that allows the system administrator
to set up the server from the management workstation (management PC) via the network or the
server's COM B (serial) port.
IMPORTANT:
Do not use this feature on any other computer than the server, or
on any other server obtained without the NEC
EXPRESSBUILDER. Doing so may cause a failure of the server.
When a keyboard is connected to the server, the remote console
feature is disabled. The NEC EXPRESSBUILDER determines that
the server has a console. (Nothing is displayed on the management
PC.)
If you fail to configure the disk array controller N8103-80F or 81F
from the remote console, try again using the server console.
The system may fail to operate with the transfer rate of 115.2 Kbps
for serial console redirection. Specify any other transfer rate than
115.2 Kbps.
Installing and Using Utilities 6-9

Advertisement

Table of Contents
loading

Table of Contents