Hard Disk Drive - NEC Express5800/120Rg-1 User Manual

9-8 Upgrading Your Server

HARD DISK DRIVE

All drive slots may contain a hard disk drive approximately 25.4 mm (1 inch) high. One of the
following types can be installed, depending on the hard disk drive installation option used in your
server chassis and the drives supported by your server mother board.
NTOE:
configuration. Purchase the hard disk drive suitable to your system
separately.
SATA 3.5-inch Hot-swap Hard Disk Drive Model
Up to three hard disk drives can be installed in the disk bay of the front of the server. The drive IDs
are assigned in the figure shown below.
Channel 0
IMPORTANT:
a third-party hard disk drive may cause a failure of the server as well as
the hard disk drive. Purchase hard disk drives of the following models:
– N8150-207A (80GB, 7,200 rpm, serial ATA2/300)
– N8150-208A (160GB, 7,200 rpm, serial ATA2/300)
– N8150-209A (250GB, 7,200 rpm, serial ATA2/300)
The hard disk drives are not installed in the standard
Use the hard disk drives authorized by NEC. Installing
Channel 1 Channel 3