NEC Express5800/120Rg-1 User Manual page 239

SAS 3.5-inch Hot-swap Hard Disk Drive Model
Up to three hard disk drives can be installed in the disk bay of the front of the server. The drive IDs
are assigned in the figure shown below.
Port 0
IMPORTANT:
a third-party hard disk drive may cause a failure of the server as well as
the hard disk drive. Purchase hard disk drives of the following models:
– N8150-199 (36.3GB, 15000 rpm, SAS)
– N8150-200 (73.2GB, 15000 rpm, SAS)
– N8150-201 (146.5GB, 15000 rpm, SAS)
– N8150-226 (300GB, 15000 rpm, SAS)
SAS 2.5-inch Hot-swap Hard Disk Drive Model
Up to six hard disk drives can be installed in the disk bay of the front of the server. The drive IDs
are assigned in the figure shown below.
IMPORTANT:
a third-party hard disk drive may cause a failure of the server as well as
the hard disk drive. Purchase hard disk drives of the following models:
– N8150-219 (36.3GB, 10000 rpm, SAS)
– N8150-220 (73.2GB, 10000 rpm, SAS)
– N8150-228 (146.5GB, 10000 rpm, SAS)
The hard disk drive bays are connected to the connector on the mother board via backplane in the
chassis. To use the hard disk drives in a disk array configuration, refer to:
Chapter 4 for using the onboard RAID controller or
"Disk Array Controller" in this chapter for using an optional RAID controller.
A dummy block or tray is installed in the hard disk drive bays. The purpose of a dummy block is to
increase the cooling effect in the server. Install a dummy block in slots not containing a hard disk
drive.
Port 1
Use the hard disk drives authorized by NEC. Installing
Port 0
Port 1
Use the hard disk drives authorized by NEC. Installing
Upgrading Your Server 9-9
Port 2
Port 2 Port 4
Port 3 Port 5