Table of Contents
Advertisement
Description
(From previous page)
Data LED is not blinking
or lit after print command
is sent
No output although the
Data LED is lit or blinking
Possible Cause
Is the network environment of the
printer configured correctly?
(When the network is used)
A network error may have
occurred. (When the network is
used)
The printer is switched off
Data may still remain inside the
printer.
4.3 Printing Problems
Solution
Print the Printer Settings List and
check if the network environment has
been configured correctly.
"1.8 Printing the Printer
Settings List" and
Chapter 3 Network
Settings (Quick Setup) in
the Setup Guide
Check that the power of the machine has
been switched on. Send a print command
from the computer again. If the same
symptom persists, consult your network
administrator.
Press the "|" side of the power switch
to switch on the printer..
"1.2.1 Switching on"
Select to abort the print job or forcibly
output the remaining data.
"1.5.2 Cancelling a Print
Job on the Control
Panel" and
"1.6 Forced Output of
Data Still in the Printer"
4
81
Advertisement
Table of Contents
