Table of Contents
Advertisement
Appendix G
Installing Additional Memory
172
There are three screws near the top of the
right cover of the printer. Unscrew them.
Slide the right cover to the back of the printer
( ). Flip it down ( ) and remove it from the
printer.
Push out the ejector levers at both ends of the
memory slot.
Hold the two sides of the memory and fit the
two cutouts with the two protruding parts on
the slot and push it straight in.
Some parts of the PCB may be very
hot. Do not touch the PCB as this may
damage the board.
After you have inserted the memory, push in
the ejector levers to fasten the memory to the
slot.
To install the hard disk, skip the next
two steps and proceed with the
installation.
Advertisement
Table of Contents
