Table of Contents
Advertisement
Message
XXX Crtrdg
Mismatch
XXX=Yellow, Magenta, Cyan, or
Black
XXX indicates one of the following: the Yellow Toner (Y), Cyan Toner (C), Magenta Toner (M), Black Toner (K), or Fuser Unit.
NNN is a numeric value.
Printer and Other Messages (In Alphabetical Order)
Message
Clean CTD Sensor
Close Front Cover
Close Side Cover
Cooling down
Please wait...
Feature Disabled
Press SET
Invalid Job
Press SET
Limit Reached
Press SET
Load MMM
XXXXXXXX
Load MMM
YYYYYYYY
MMM=Tray 1, Tray 2, Manual
Feeder
Load NNN
XXXXXXXXXXXXXXXX
Load NNN
YYYYYYYYYYYYYYYY
(NNN:Tray1,Tray2)
120
6 Troubleshooting
It is almost time to replace X toner cartridge.
Prepare a new toner cartridge
Refer to
• "Consumables" (P. 182)
• "Life of Consumables" (P. 183)
The CTD sensor (automatic density control sensor) is dirty. Clean it.
Refer to
"Cleaning the CTD Sensor" (P. 173)
The front cover is open. Close the front cover.
The side cover is open. Close the side cover.
Printer internal temperature is too hot. Wait until the temperature cools. If the
message remains displayed on the control panel display even after the internal
temperature cools, contact our Customer Support Center or your dealer.
The user is not registered to print in color when using the authentication function.
Contact your system administrator.
When the configuration of the printer on the print driver does not conform to the
printer you are using, this message appears.
• Press the <Eject/Set> button to clear the message, cancel the current print job,
and execute the next print job, if any.
• Press the <Cancel Job> button to cancel the print job.
• Make sure that the configuration of the printer on the print driver conforms to the
printer you are using.
Refer to
• "Printing the Reports/Lists" (P. 139)
User has reached the printable page limit registered in authentication. Contact your
system administrator.
MMM is out of paper, or the specified paper could not be detected in MMM. Supply
MMM with the following size, orientation, and type of paper.
MMM indicates the number of the tray or the Manual Feeder.
Refer to
"Loading Paper" (P. 76)
Paper is not loaded in Tray N. Or, the size of the paper loaded in Tray N differs from
the size set for printing with the print driver.
Load paper of XXXXXXXX size and YYYYYYYY type in Tray N, and confirm the
positions of the paper guides of the tray.
Refer to
"Loading Paper" (P. 76)
Condition/Reason/Action
Condition/Reason/Action
Advertisement
Table of Contents
