Table of Contents
Advertisement
Message
Login Error
Press SET
Open & Close
Front Cover
Open Front Cover
Clear Jam from B
Open Front Cover
Clear Jam from D
Open Front Cover
Clear Jam from E
Open NNN
Clear Jam
Open & Close
Front Cover
(NNN:Tray1,Tray2)
Out of Memory
Press SET
PDL Error
Press SET
Press SET
to Continue
Ready to Print
Clean CTD Sensor
Reboot printer
(NNN-NNN)
Reboot Printer
(061-370)
Fatal Error
(094-351)
User is not registered in authentication to print. Contact your system administrator.
Paper is jammed in the Manual Feeder.
Removed the jammed paper, and then open and close the front cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 102)
Paper is jammed inside the printer. Press the side button to open the front cover and
clear the paper jam.
Refer to
"6.1 Clearing Paper Jams" (P. 102)
Paper is jammed inside the printer. Press the side button to open the front cover and
clear the paper jam.
Refer to
• "6.1 Clearing Paper Jams" (P. 102)
Paper is jammed inside the printer. Press the side button to open the front cover and
clear the paper jam.
Refer to
• "6.1 Clearing Paper Jams" (P. 102)
Paper is jammed inside Tray 1 or Tray 2. Clear the paper jam. Open and close the
front cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 102)
The printer memory is full and cannot continue processing the current print job.
• Press the <Eject/Set> button to clear the message, cancel the current print job,
and execute the next print job, if any.
• Press the <Cancel Job> button to cancel the print job.
• Press the <Menu> button to open the Print Menu and delete the pending job.
• To avoid this error in the future, do as follows:
-Delete unnecessary fonts, macros, and other data in printer memory.
-Install additional printer memory.
A PDL emulation error has occurred.
• Press the <Eject/Set> button to clear the message, cancel the current print job,
and execute the next print job, if any.
• Press the <Cancel Job> button to cancel the print job.
Press the <Ejject/Set> button to print, and the <Cancel Job> button to stop printing.
The CTD sensor (automatic density control sensor) is dirty. Clean it.
Refer to
• " Cleaning the CTD Sensor" (P. 173)
The printer is not working correctly due to damage or malfunction. Turn the printer off
and then on. If the error continues, contact our Customer Support Center or your
dealer.
An internal error has occurred. Turn the printer off and on. If the error continues,
contact our Customer Support Center or your dealer.
The life of the belt unit has expired.
Contact our Customer Support Center.
Condition/Reason/Action
6.6 Error Messages (In Alphabetical Order)
121
Advertisement
Table of Contents
