Table of Contents
Advertisement
Message
Remove & Shake
X Crtrdg
XXX=Yellow, Magenta, Cyan, or
Black
Remove PHD Unit
Tapes Mismatch
Replace PHD Unit
Replace XXX
Crtrdg
XXX=Yellow, Magenta, Cyan, or
Black
13_Replace XXX
Crtrdg
Check Toner Cart
YYY
Check Toner Cart
Replacement Time
XXX=Yellow, Magenta, Cyan,
or Black
YYY=Fuser Unit, Drum Cartridge,
belt unit
Set Fuser
in Place
Then Reboot
Printer
XXX Crtrdg
Mismatch
XXX=Yellow, Magenta, Cyan, or
Black
This message is displayed when the color printed with the X toner cartridge becomes
pale. Remove the X toner cartridge, and lightly shake it 5 to 6 times to even the toner.
Then, set the X toner cartridge at its original position.
Important
• Do not remove the toner cartridge except when required.
When removing the toner cartridge, the toner may scatter.
Refer to
• "Replacing the Toner Cartridges" (P. 128)
Ribbons remain in the drum cartridge. Remove the yellow ribbons from the drum
cartridge.
Refer to
• "Replacing the Drum Cartridge" (P. 130)
It is time to replace the drum cartridge.
Replace the drum cartridge with a new one.
Refer to
• "Consumables" (P. 182)
• "Life of Consumables" (P. 183)
• "Replacing the Drum Cartridge" (P. 130)
The X toner cartridge has run out of toner.
Replace the displayed toner cartridge with a new one.
Refer to
• "Life of Consumables" (P. 183)
• "Replacing the Toner Cartridges" (P. 128)
This message is displayed when the following two conditions are met.
1. The black toner cartridge is empty or the waste toner fills up the drum cartridge.
2. The fuser unit, the belt unit, or the drum cartridge reaches its life.
Replace the XXX toner cartridge and the YYY unit.
If the belt unit is displayed for YYY, call our Customer Support Center or your dealer.
Refer to
• "Replacing the Toner Cartridges" (P. 128)
• "Replacing the Fuser Unit" (P. 134)
• "Replacing the Drum Cartridge" (P. 130)
• "Consumables" (P. 182)
The fuser unit is not installed correctly. Open the front cover and re-install the fuser
unit. After installing the unit, turn on the printer.
Refer to
• "Replacing the Fuser Unit" (P. 134)
X is not a toner cartridge suitable for the printer.
Correctly set a suitable toner cartridge in the printer.
Refer to
• "Consumables" (P. 182)
• "Replacing the Toner Cartridges" (P. 128)
Condition/Reason/Action
6.6 Error Messages (In Alphabetical Order)
119
Advertisement
Table of Contents
