Table of Contents
Advertisement
Replacing the Fuser Unit
This section describes procedures for replacing the Fuser Unit.
Caution on Handling the Fuser Unit
When handling the Fuser Unit, take note of the following points:
CAUTION
• Fuser Safety
When removing the Fuser Unit, always switch off first and wait for 40 minutes until it
cools off.
• Always turn off the printer and disconnect the power cable from the grounded outlet
before cleaning the printer or performing maintenance. It can cause electric shock.
• Avoid bright light and try to finish the replacement within 3 minutes.
Replacing the Fuser Unit
Important
• Turn off the printer and wait 40 minutes before removing the Fuser Unit.
1.
Turn off the printer and disconnect the
power cord. Wait 40 minutes until it cools.
2.
Remove any paper in the output tray.
3.
Press the cover button on the right side of
the printer and open the front cover.
4.
Grasp the green parts of the belt unit with
your fingers and lower the belt unit until it
stops.
134
7 Maintenance
Advertisement
Table of Contents
