Lto Configurations; Figure A-1 Base Module Lto Cells; Figure A-2 Lto Cell Locations For Firmware Site Mapping; Figure A-3 Lto Cell Locations For Scsi Element Numbering Mapping - Sun Microsystems StorageTek SL500 User Manual

LTO Configurations

LTO Configurations
The following figures show LTO storage cell and tape drive locations.
FIGURE
■
Module.
FIGURE
■
library with a Base Module that has nine reserved cells, one Drive Expansion
Module, and one Cartridge Expansion Module.
FIGURE
■
page 335
Expansion Module, and one Cartridge Expansion Module. The storage cell
numbering begins with the first cell after the reserved cells in column 1. The figure
shows two reserved cells, but there could be more. If the reserved cells are
configured as storage cells, the top cell (row 1) would be 1.
FIGURE
■
shows the cell capacity of a Cartridge Expansion Module according to which type of
module is installed above and below it.
332 SL500 User's Guide • July 2008
A-1, "Base Module LTO Cells" on page 333
A-2, "LTO Cell Locations for Firmware Site Mapping" on page 334
A-3, "LTO Cell Locations for SCSI Element Numbering Mapping" on
shows a library with a Base Module that has two reserved cells, one Drive
A-4, "LTO Cells for Back Wall of Cartridge Expansion Module" on page 336
shows a library with only a Base
shows a
Revision: KA • 96116