Ordering Cartridges And Labels - Sun Microsystems StorageTek SL500 User Manual

Color cartridges are approved only if the measured reflection density is greater than 0.1
as measured by an X-rite 404G color reflection densitometer. For more information
about colored cartridges, contact your Sun support representative.
Color measurements are:
Bandwidth
Measuring range
Accuracy
Repeatability
Aperture diameter

Ordering Cartridges and Labels

Contact your authorized Selling Agent for Sun-branded labeled cartridges. You do not
need to order labels separately, because the data cartridges have labels already, and the
cleaning and diagnostic labels are shipped with the installation hardware. However,
you must select the VOLID range and other label options when ordering cartridges.
If you choose to order additional labels, order them from any standard media vendor.
See "Cartridge Requirements" on page 348
96116 • Revision: KA
ANSI Status T Wide band (380 to 780 nm)
Density (0.00 to 2.50) D
±0.02 D
±0.01 D
3.4 mm (0.13 in.)
before ordering.
Appendix B Cartridge Information 349
Ordering Cartridges and Labels