Enter Cartridges Through The Cap - Sun Microsystems StorageTek SL500 User Manual

Enter Cartridges Through the CAP

▼
The Base Module CAP contains a standard four- or five-cell magazine. See
The expansion module CAP has two magazines.
Use this procedure to enter a cartridge into the library through a CAP.
Note – Before using this procedure, verify that the library CAP Prevent/Allow state is
set to Allow. See your SCSI reference manual for syntax.
1. Press the CAP Open button on the keypad.
The robot opens the CAP door and the CAP Open LED is turned on.
2. Grip the handle of the magazine and slide it out of the CAP and onto the door.
Note – Do not remove the magazine from the door. Leaving the magazine on the door
rails will allow the magazine to slide easier into the CAP.
3. Place the cartridge into one of the magazine cells, making sure that the VOLID label
is visible and the hub of the cartridge is down.
4. Grip the handle and slide the magazine back into the CAP.
5. Close the CAP door making sure that the door is securely latched.
96116 • Revision: KA Chapter 3 SL500 Automated Library Operations 85
Cartridge Management Tasks
FIGURE 3-1.