Introduction to MINIPLEX Transponders (4100U),
Local Mode
Specifications
Local mode is supported by the following:
•
4100-3101/3104/3105 IDNet Card
•
4100-5101/5102/5103 Expansion Power Supply NACs (including TrueAlert
Non-Addressable SmartSync appliances)
•
4100-5111/5112/5113 System Power Supply NACs (including TrueAlert Non-
Addressable SmartSync appliances)
•
4100-5125/5126/5127 Remote Power Supply NACs (including TrueAlert Non-
Addressable SmartSync appliances)
•
4100-5120/5121/5122 TrueAlert Power Supply NACs
•
4100-1214 to -1225, 4100-1228 to –1239, 4100-1314 to -1325, 4100-1328 to –
1339,
100 W Amplifier NACs
•
4100-1212/1213/1226/1227/1312/1313/1326/1327 Flex 50 Amplifier NACs
•
4009-9401 TrueAlert Addressable Controller
•
4100-1270 Phone Controller and 4100-1272/1273 Phone NAC cards
•
4009-9201/ 9301 IDNet NAC Extender
•
4100-5116 Expansion Signal Card
Local mode is NOT supported by, but can co-exist with, the following:
•
4100 Legacy cards
•
4100-3101 to -3103 Auxiliary Relay Cards
•
4100-6048 VESDA
•
4100-6043/6044 RS-232/2120 Interfaces
•
4100-1280 to -1287 LED/Switch Annunciators
•
4100-1290 24-Point Graphic I/O Module
•
4602-9101 SCU/ 4602-9102 RCU
•
4603-9101 LCD Annunciator
•
4100-1210/1211/1311 Audio Controller Board
•
4100-6014 Network Interface Card
•
4100-6052 DACT
Bear in mind the following limitations for when local mode is in effect:
•
If an alarm is already activated when local mode is initiated, the alarm remains
activated in local mode.
•
Software zones are not supported. Basic TrueAlert channels are supported.
•
Alarm verification is not supported. All alarms are reported immediately.
•
SMPL is not supported.
•
TrueAlarm sensors have fixed thresholds.
Interface Kit
4-5
Continued
Continued on next page