Chapter 2 Installing 4100U Facp Components; Introduction; In This Chapter - Simplex 4100U Installation & Maintenance

Installing 4100U FACP Components

Introduction

In this Chapter

Chapter 2
4100U cabinets are available in one-, two-, and three-bay sizes. Each can be equipped
with a solid or perspex door. This chapter describes how to mount all types of 4100U
cabinets to a wall, and how to mount system card bays into the cabinets, modules to bays,
etc.
FACPs are assembled to order within the factory. Steps 2 to 6 below are therefore not
typically required in the field, but are included in case of in-field system expansion.
The section Introduction to FACPs describes the various components that make up the
FACP.
The assembly drawings 1976-136, 1976-137 are included in the appendix of this manual
for reference.
Refer to the page number listed in this table for information on a specific topic.
Introduction to FACPs (4100U)
Step 1. Mounting Cabinets (4100U)
Step 2. Mounting Card Bays to Cabinets (4100U)
Step 3. Configuring Cards (4100U)
Step 4. Interconnecting Modules and Bays
Step 5. Installing Modules into Expansion Bays (4100U)
Step 6. Installing LED/Switch Modules into Expansion Bays
(4100U)
The Terminal Block Utility Module (4100U)
Topic
2-1
See Page #
2-2
2-9
2-9
2-10
2-11
2-15
2-20
2-27