Installing A New System; Unpacking; Initial Assembly - Overview - Avaya IP Office 3.0 Installation Manual

Installing a New System

Unpacking

Before proceeding with installation, ensure that you have read the notes covered in Introduction above.
Unpacking and checking :
1. Before unpacking check for any signs of damage that has occurred during transit. If any damage
exists bring it to the attention of the carrier.
2. Check all cartons against the packing slip. Report any errors or omissions to the equipment
supplier.
3. While unpacking the equipment, retain all the packaging material. Fault returns are accepted only
if repackaged in the original packaging.
4. Visually inspect each item and check that all the necessary documentation and accessory items
have been included. Report any errors or omissions to the dealer who supplied the equipment.
5. Ensure you read and understand any documentation included with any item.
6.

Initial Assembly - Overview

Prior to initial assembly and mounting (rack or free standing) of your system, check that:
• The required Trunk Interface Modules have been installed (see Installation of Integral Modules)
and are of the correct country variant type (see Country Variants).
• Where structured cabling is to be used it has been installed, conforms to all local regulations and
is clearly labeled.
Perform the following:
1. Mount the Avaya IP Office - Small Office Edition module in its final location.
2. Run the Lump-in-Line PSU cable back to the switchable mains supply but do not switch-on or
connect the PSU to the Avaya IP Office - Small Office Edition.
3. Connect the Trunks, using PRI/BRI ISDN Cables (see PRI/BRI ISDN Cable), to your provider's
trunk sockets.
4. Connect the DT/DS/POT Ports, using DT Line Cords (see DT Line Cord for Structured Cabling),
to the structured cable sockets or directly to the appropriate telephone. Note that in default, the
lowest port number corresponds to the lowest extension number (201).
5. Install all telephones in their appropriate locations. For wall mounting, see Wall Mounting 2000
Series Telephones and Wall Mounting 44/4600 & 6400 Series Telephones.
6. Connect your PC LAN Port to one of the LAN Ports on the front of an Avaya IP Office - Small
Office Edition using a LAN Cable (see LAN Cable).
7. Switch on the ac mains supply.
8. From the Administrator CD, install on your PC the software required to configure and manage
your Avaya IP Office - Small Office Edition.
Small Office Edition Installation Manual
IP Office 3.0 40DHB0002UKED Issue 3 (4th February 2005)
Page 21