Table of Contents
Advertisement
REVIEWING TROUBLES AND ALARM MEMORY
PRESS
I
OK
OK
I
OK
I
I
OK
I
OK
I
OK
In response to further clicking of the
the display will show details of other troubles (if any),
or will revert to the initial alternating displays (see
example above).
12
RESULTANT DISPLAY
READY
HH:MM
Z09 MISSING
(alternating)
Z09 CONTACT
(alternating)
KITCHEN
Z15 LOW BATT
(alternating)
LIVING ROOM
(alternating)
READY HH.MM
Z02 NOT NETWORKD
(alternating)
Z02 CONTACT
(alternating)
UTILITY ROOM
Z05 NOT UPDATED
(alternating)
Z05 CONTACT
(alternating)
FRONT DOOR
Z11 BAD COMM
(alternating)
Z11 CONTACT
(alternating)
GARAGE
I
OK
IMPORTANT! If the trouble beeps bother you, disarm
the system again (even though it is already disarmed).
This will cancel the trouble beeps for 4 hours.
Reviewing Memory & Troubles at
the Same Time
If alarms / tamper events are retained in the alarm
memory and at the same time a state of trouble
exists, the display will behave as shown below:
or, if the system is not ready for arming -
To read status information - memory data, open zones
and trouble sources (in this order) - click the
button repeatedly. The memory content will be
displayed first, in the same manner shown in Chapter
5 - Reviewing Alarm / Tamper Memory. If the system
is not ready, open zone information will follow in the
same manner as shown in Chapter 2 - Preparing to
Arm. Trouble sources will be displayed last, in the
same manner shown in Chapter 5 - Reviewing
Trouble Information.
Correcting Trouble Situations
The
trouble
button,
indicator and flashing TRBL message) are cleared
once you eliminate the cause for trouble. If you do
not know how to cope with a trouble situation,
report it to your installer and seek his advice.
READY
HH:MM
(alternating)
READY
MEMORY
(alternating)
READY
TRBL
NOT READY
HH:MM
(alternating)
NOT READY MEMORY
(alternating)
NOT READY
TRBL
indications
(illuminated
I
OK
TROUBLE
D-302757
Advertisement
Table of Contents
