Visonic PowerMax10 User Manual page 14

Fault
1-WAY
NOT NETWORKED
MISSING
JAMMING
LOW BATTERY
CLEAN ME
GAS TROUBLE
SIREN AC FAILURE
AC FAILURE
GSM NET FAIL
RSSI LOW
AC SUPPLY FAILURE
COMM. FAILURE
CPU LOW BATTERY
CPU TAMPER
FUSE TROUBLE
LINE FAILURE
D-302757
REVIEWING TROUBLES AND ALARM MEMORY
What it means
The control panel cannot configure or control the device.
Battery consumption increases.
A device was not installed or not installed correctly, or, cannot
establish communication with the control panel after installation.
A device or detector has not reported for some time to the
control panel.
A radio-frequency signal which is blocking communication
channel of sensors and control panel is detected.
The battery in a sensor, keyfob or wireless commander is near the
end of its useful life.
The fire detector must be cleaned
Gas detector failure
There is no power to the siren
There is no power to gas sensor
The GSM communicator is not able to connect to the cellular
network.
The GSM communicator has detected that GSM network signal is
weak
There is no power and the system is working on backup battery
power
A message could not be sent to the monitoring station or to a
private telephone (or a message was sent but was not
acknowledged)
The backup battery within the control panel is weak and must be
replaced (see Chapter 7 - Replacing Backup Battery).
The control panel was physically tampered with or its cover was
opened, or it was removed from wall.
The PGM fuse is burnt out or overloaded.
There is a problem with the telephone line
13