Installing In Blade Enclosure - NEC Express5800 series User Manual

Installing in Blade Enclosure

To use the Storage and I/O Blade, install it in a Blade Enclosure.
This section describes how to install the Storage and I/O Blade in SIGMABLADE-M, as an
example.
Installation
1.
Locate a slot to install Storage and I/O Blade according to "Installation Order" described
earlier.
2.
If the CPU blade has already been installed, power off the CPU blade.
IMPORTANT:
the power of CPU blade being on.
3.
If a blank cover is installed on the slot on which the Storage and I/O Blade is to be
installed, unlock it by holding the lever on the front face, and remove the blank cover.
IMPORTANT:
Keep the removed blank cover for future use.
Do not remove the blank cover from any other slot than the target
slot.
You cannot install/remove Storage and I/O Blade with
Setting Up Your Storage and I/O Blade
3-5