NEC Express5800 series User Manual page 144

8-20 Troubleshooting
RAID battery is not detected, or POST displays the following message:
The battery hardware is missing or malfunctioning, or the battery is
unplugged, or the battery could be fully discharged. If you continue to boot
the system, the battery-backed cache will not function.
If battery is connected and has been allowed to charge for 30 minutes and
this message continues to appear, then contact technical support for
assistance.
Press 'D' to disable this warning (if your controller does not have a battery).
Are cables connected properly?
→ Check connection between RAID battery and RAID Controller. If not, connect it
properly.
The RAID battery is not charged at shipment.
→ The RAID battery may not be detected if it is insufficiently charged. If the battery
is not detected even after 24 hours, reboot the system.
If the same error persists, the RAID battery may be faulty. Contact your service
representative.
Event ID129:
The following message appears on Windows Event Log.
Source:
Event ID:
Type:
Description:
→ Retry by OS has succeeded. It is not the problem in operating the system.
Event ID317:
The following message may be registered in RAID log in Universal RAID Utility and OS
log (Event Log of Windows, syslog of Linux).
Source:
Event ID:
Type:
Description:
→ Single-shot message indicates the successful retry even if the message above is
registered. If this message is repeatedly registered, physical device may be faulty.
Contact your service representative.
msas2k3
129
Warning
Information about Event ID (129) (Source: msas2k3) is not found.
-----
Raidsrv
317 (8000013D)
Warning
<RU0317>[CTRL: %1 PD:%2(%3) %4 %5] An error of warning level
occurred on physical device.
Error code: %6