Hard Disk Drive - NEC Express5800 series User Manual

Express5800 series storage and i/o blade ad106a
Hide thumbs Also See for Express5800 series:
Table of Contents

Advertisement

Hard Disk Drive

The Storage and I/O Blade can contain up to six 2.5-inch hard disk drives. This section describes the
installation and removal procedure.
IMPORTANT:
The hard disk drive is extremely sensitive to static electricity. Make
sure to touch the metal frame of the Storage and I/O Blade to
discharge static electricity from your body before handling the hard
disk drive. Do not touch the terminals and parts on the hard disk
drive by a bare hand and place the hard disk drive directly on the
desk. For static notes, see the section "Anti-static Measures"
described earlier.
Do not use any hard disk drives not approved by NEC. If an
unapproved third party's hard disk drive is installed in the Storage
and I/O Blade, not only the hard disk drive but also the Storage and
I/O Blade may be defected.
If hard disk drives of different disk capacities co-exist in the Storage
and I/O Blade, the unit can operate normally. However, the hard
disk drives configuring the disk group (DG) should have the same
capacity and rotation speed.
Pay attention not to apply shock or vibration to the hard disk drive.
Do not push the surface of the hard disk drive when installing or
removing the hard disk drive. Doing so may cause a failure of the
hard disk drive.
Use the hard disk drive mounted on the tray dedicated to the Storage
and I/O Blade. Do not remove the hard disk drive from the tray to
mount any other hard disk drive. Doing so may cause a failure of
the hard disk drive.
Upgrading Your Storage and I/O Blade
9-11

Advertisement

Table of Contents
loading

This manual is also suitable for:

N8404-001f

Table of Contents