Table of Contents
Advertisement
5.
Follow the same instructions to connect the second
hard drive. Device connection is now complete.
Note: If it is your desire to monitor disk activity of
the Serial ATA hard drives, you may at this time
connect the hard disk LED of the system case to the
Hard Disk LED Pins on the Serial ATA controller.
6.
Replace the computer cover and reconnect the
power cord. Go to RAID Arrays to configure the
RAID BIOS.
RAID Arrays
RAID Arrays are setup in the SATA II PCIe RAID BIOS.
Find your RAID set from the table of contents.
RAID 0 (striping) ............................................ page 6-7
RAID 1 (mirroring) ......................................... page 7-8
Rebuilding a Failed Mirror Set .................... page 8-9
Deleting RAID Arrays ...................................... page 9
Resolving Conflicts ......................................... page 10
Low Level Format ........................................... page 10
Logical Drive Info ........................................... page 10
Figure 4. Connecting HDD LED
Table of Contents
5
Advertisement
Table of Contents
