SIIG SATA II PCIe RAID Quick Installation Manual page 15

1. Setup the RAID array prior to Windows installation.
2. Follow Windows installation procedure.
3. At the Windows Setup screen, press F6 to install the
RAID driver.
4. When prompted, press S to specify the location of
the driver.
5. Insert the floppy disk, then press Enter.
6. Select Silicon Image SiI 3132 SoftRaid 5 Controller
for Windows XP/Server 2003, then press Enter.
7. Press Enter again to finish the driver installation,
then follow the on-screen instructions to complete
your Windows installation.
When Windows installation completes, go to SATARaid5
GUI on page 19 and install the RAID utility.
For An Existing Installation
1. Setup the RAID array prior to driver installation and
boot up to Windows.
2. At the Found New Hardware Wizard:
XP (w/SP1 or earlier) / Server 2003: continue to step
#3.
XP (w/SP2 or later) / Server 2003 (w/ SP1 or later):
select No, not at this time, then click Next.
3. Insert the driver CD, select Install the software
automatically (Recommended), and click Next.
4. Click Finish to complete the driver installation.
When Windows resumes, go to SATARaid5 GUI on
page 19 and install the RAID utility.
15