Table of Contents
Advertisement
2.
At the next screen select Create RAID Set, then
press Enter.
3.
At the next screen select RAID1 then press Enter.
4.
Select Manual configuration, then press Enter.
5.
Select the Source drive, press Enter.
6.
Select the Target drive, press Enter.
7.
Select Create with data copy, then press Enter.
8.
Select online copy, then press Enter.
Note: Selecting Online Copy builds the mirror
while in Windows. Selecting Offline Copy builds
the mirror before exiting the RAID BIOS.
9.
Input the RAID size, press Enter.
10. Press Ctrl+E to exit the BIOS.
11. When asked Are you sure to exit (Y/N)?, press Y to
exit and reboot.
Rebuilding a Failed Mirror Set
When a failure to one member occurs, you will be notified
either by the RAID BIOS during boot or by the SATA
Raid5 GUI while in Windows. The steps below will
guide you in rebuilding a failed mirror set.
For Offline Mirror Rebuild (SATA RAID BIOS)
1.
Replace the failed drive with one of equal or greater
capacity, then power on the computer.
2.
During boot press Ctrl+S or F4 to enter the RAID
BIOS.
3.
Select Create RAID Set press Enter.
4.
Select SPARE DRIVE, then press Enter.
5.
Select the single hard drive then press Enter.
8
Advertisement
Table of Contents
