SIIG SATA II PCIe RAID Quick Installation Manual page 16

Windows XP / Server 2003 (64-bit )
For A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents
of the 64bit folder, found on the driver CD, onto a blank
floppy disk then follow the directions below.
1. Setup the RAID array prior to Windows installation.
2. Follow Windows installation procedure.
3. Restart the computer when prompted by Windows'
installation.
4. At the Windows Setup screen, press F6 to install the
RAID driver.
5. When prompted, press S to specify the location of
the driver.
6. Insert the floppy disk, then press Enter.
7. Select Silicon Image Sil 3132 SoftRaid 5 Controller
(64-bit Extended), then press Enter.
8. Press Enter to finish driver installation, then follow
the on-screen instructions to complete Windows
installation.
When Windows installation completes, go to SATARaid5
GUI on page 19 and install the RAID utility.
For An Existing Installation
1. Setup the RAID array prior to driver installation
and boot up to Windows.
2. At the Found New Hardware Wizard:
XP (w/SP1 or earlier) / Server 2003: continue to step
#3
XP (w/SP2 or later) / Server 2003 (w/ SP1 or later):
select No, not at this time, then click Next.
16