SIIG SATA II PCIe RAID Quick Installation Manual page 17

3. Insert the driver CD, select Install the software
automatically (Recommended), and click Next.
4. Accept the default entry, then click Next.
5. Click Finish.
6. Repeat steps 2-5.
7. Click Yes to restart to complete the installation.
When Windows resumes, go to SATARaid5 GUI on
page 19 and install the RAID utility.
Windows 2000
For A New Installation
A new installation of Windows 2000 requires a floppy
disk for the driver installation. To make this floppy disk,
copy the contents of the 32bit folder, found on the driver
CD, onto a blank floppy disk then follow the directions
below.
1. Setup the RAID array prior to Windows installation.
2. Follow Windows 2000 installation procedure.
3. At the Windows 2000 Setup screen, press F6 to
install the RAID driver.
4. When prompted, press S to specify the location of
the driver.
5. Insert the floppy disk, then press Enter.
6. Select Silicon Image Sil 3132 SoftRaid 5 Controller
for Windows 2000, then press Enter.
7. Press Enter again to finish driver installation, then
follow the on-screen instructions to complete the
Windows installation.
When Windows installation completes, go to SATARaid5
GUI on page 19 and install the RAID utility.
17