Enabling Lldp And Lldp-Med On The Switch - Allied Telesis AT-9000/28 Command Line User's Manual

Alliedware plus version 2.1.2 management software for layer 2-4 gigabit ethernet ecoswitches

Hide thumbs Also See for AT-9000/28:

Table of Contents

Chapter 61: LLDP and LLDP-MED

Enabling LLDP and LLDP-MED on the Switch

To enable LLDP and LLDP-MED on the switch, use the LLDP RUN

command in the Global Configuration mode. The switch begins to transmit

advertisements from those ports that are configured to send TLVs, and

begins to populate its neighbor information table as advertisements from

the neighbors arrive on the ports. The command does not support any

parameters. Here is the command:

awplus> enable

awplus# configure terminal

awplus(config)# lldp run

To deactivate LLDP and LLDP-MED, refer to "Disabling LLDP and LLDP-

MED on the Switch" on page 902.

Section X: Network Management

At-9000/52 At-9000/28sp