Disabling Lldp And Lldp-Med On The Switch - Allied Telesis AT-9000/28 Command Line User's Manual

Alliedware plus version 2.1.2 management software for layer 2-4 gigabit ethernet ecoswitches

Hide thumbs Also See for AT-9000/28:

Table of Contents

Chapter 61: LLDP and LLDP-MED

Disabling LLDP and LLDP-MED on the Switch

To disable LLDP and LLDP-MED on the switch, use the NO LLDP RUN

command in the Global Configuration mode. The command has no

parameters. After the protocols are disabled, the switch neither sends

advertisements to nor collects information from its neighbors. The switch

retains its LLDP settings. Here is the command:

awplus> enable

awplus# configure terminal

awplus(config)# no lldp run

Section X: Network Management

At-9000/52 At-9000/28sp