Displaying Port Settings - Allied Telesis AT-9000/28 Command Line User's Manual

Chapter 7: Port Parameters

Displaying Port Settings

Port
port1.0.18
port1.0.20
Interface port1.0.1
Link is UP, administrative state is UP
Address is 0015.77cc.e243
index 1 mtu 9198
SNMP link-status traps: Enabled (Suppressed in 0 sec.)
Bandwidth 1g
input packets 0, bytes 0, dropped 0, multicast packets 0
output packets 0, bytes 0, multicast packets 0 broadcast packets 0
Interface port1.0.2
Link is UP, administrative state is UP
Address is 0015.77cc.e244
index 2 mtu 9198
SNMP link-status traps: Enabled (Suppressed in 0 sec.)
154
To display the speed and duplex mode settings of the ports, use the
SHOW INTERFACE STATUS command in the Privileged Exec mode.
Here is the format:
show interface [
This example of the command displays the speed and duplex mode
settings for ports 18 and 20:
awplus# show interface port1.0.18,port1.0.20 status
Here is an example of the information the command displays.
Name Status
Port_01 down
Port_02 up
Figure 36. SHOW INTERFACE STATUS Command
The columns are described in Table 9 on page 189.
To display the current status of the ports on the switch, use the SHOW
INTERFACE command in the Privileged Exec mode. Here is the format:
show interface [
This example displays the settings for ports 1 and 2:
awplus# show interface port1.0.1,port1.0.2
Here is an example of what you will see.
Figure 37. SHOW INTERFACE Command
port
] status
Vlan Duplex Speed Type
3 half 100
11 auto auto
port
]
10/100/1000Base-T
10/100/1000Base-T
Section II: Basic Operations