Banner Motd - Allied Telesis AT-9000/28 Command Line User's Manual

Alliedware plus version 2.1.2 management software for layer 2-4 gigabit ethernet ecoswitches

Hide thumbs Also See for AT-9000/28:

Table of Contents

AT-9000 Switch Command Line User's Guide

BANNER MOTD

Global Configuration mode

Use this command to create a message-of-the-day banner. The message

is displayed prior to the login user name and password prompts for local,

Telnet and SSH management sessions. If the switch also has a login

banner, this message is displayed first.

After you enter the command, the prompt "Type CTRL/D to finish" is

displayed on your screen. Enter a message-of-the-day banner of up to 100

characters. Spaces and special characters are allowed. When you are

finished, hold down the CTRL key and type D.

Web browser management sessions do not display the message-of-the-

To remove the banner, use the NO version of this command.

Confirmation Command

"SHOW RUNNING-CONFIG" on page 129

This example create a message-of-the-day banner:

awplus> enable

awplus# configure terminal

awplus(config)# banner motd

Type CTRL/D to finish

This switch was updated to the latest software on May 23,

This example removes the message-of-the-day banner:

awplus> enable

awplus# configure terminal

awplus(config)# no banner motd

Section II: Basic Operations

Do you have a question about the AT-9000/28 and is the answer not in the manual?

At-9000/52 At-9000/28sp