Reset Configuration Data; Resources Controlled By; Irq Resources - Albatron PM266A PRO User Manual

P nP/PCI Configurations
P NP OS Installed
When set to "YES", BIOS will only initialize the PnP cards used for the boot sequence (VGA, IDE,
SCSI). The rest of the cards will be
set to "NO", BIOS will initialize all the PnP cards. For non-PnP operating systems (DOS, Netware),
t his option must be set to "NO".
O ptions: No (default)、Yes

Reset Configuration Data

S elect "Enabled" to reset the Extended S
new add-on card and the system reconfiguration has caused such a serious conflict that the OS cannot
boot. Options: Disabled (default)、E

Resources Controlled By

BIOS can automatically configure all
Auto, you will not be able to manually assign IRQ DMA and memory
BIOS automatically assigns them. Options: Auto <ESCD> (default)

IRQ Resources

When resources are controlled manuall
the type of device using the interrupt.
se t to "Manual".
IRQ-3/4/5/7/9/10/11/12/14/15
P CI / VGA Palette Snoop
Some graphic controllers that are not VGA com
map it to their display as a way to
O ptions: Disabled (default)、Enabled
PCI Latency Ti mer (CLK)
This item allows you to set up the PCI Latency Time (0-255). If you select the "32" it will optimize
PCI speeds. Options: 0-255、32 (default)
PCI IRQ Assignment
This item allows you to select an IRQ address for your PCI slot 1-3.
initialized by the PnP operating system like Windows® 95. When
ystem Configuration Data (ESCD) if you have installed a
nabled
the boot and Plug and Play compatible devices. If you choose
y, you can assign each system interrupt a type, depend
This is only configurable when "Resources Controlled By" is
assigned to: PCI device
patible take the output from a VGA controller and
provide boot information and VGA compatibility.
29
PM266A PRO/ PM266A
base address fields, since
、Manual
ing on