Gpi Setup (Gpi) Page; Program Change; Parameter Change - Yamaha DME64N Owner's Manual

NOT E
"DAW" stands for "Digital Audio Workstation." ProTools, Logic,
and Cubase are DAW applications, and this parameter provides
direct compatibility with a number of physical controls surfaces
that are available for use with these DAW software packages.
The following parameters are available when the DAW
parameter is set to OFF.
3 CH
Specifies the device's MIDI transmit and receive channel:
1 ~ 16.
Edit using the "List Parameters" editing procedure
described on page 41.

4 Program Change

Turns transmission and reception, the omni mode, and
echo ON or OFF for MIDI program change messages.
Move the cursor to the required parameter, then press the
[ENTER] button to alternately turn ON and OFF.
5 Control Change
Turns transmission and reception, the omni mode, and
echo ON or OFF for MIDI control change messages.
Move the cursor to the required parameter, then press the
[ENTER] button to alternately turn ON and OFF.

6 Parameter Change

Turns transmission and reception, and echo ON or OFF
for MIDI parameter change messages.
Move the cursor to the required parameter, then press the
[ENTER] button to alternately turn ON and OFF.

GPI Setup (GPI) Page

Input calibration parameters for the [GPI] connector.
N OTE
This page will not appear on the ICP1 display.
1
2
4
3
1 Reset
Resets GPI calibration.
To reset the calibration, use the [E ] [
buttons to select ALL to reset all inputs, or select an
individual input from 1 to 16 to be reset, then press the
[ENTER] button.
2 MAX
Sets the maximum calibration value.
To set the MAX value, use the [E ] [
buttons to select ALL to set all inputs, or select an
individual input from 1 to 16 to be set, then press the
[ENTER] button to set the MAX value to the current
input voltage.
3 MIN
Sets the minimum calibration value.
To set the MIN value, use the [E ] [
buttons to select ALL to set all inputs, or select an
individual input from 1 to 16 to be set, then press the
[ENTER] button to set the MIN value to the current
input voltage.
4 Calibration Info
Shows the calibration settings as well as the current input
voltage.
DME64N/24N Owner's Manual
Utility Displays
] [ ] [F ]
] [ ] [F ]
] [ ] [F ]
53