Remote Connection - Yamaha DME64N Owner's Manual

Connection

REMOTE Connection

The [REMOTE] connector can be connected to remotely-controllable Yamaha AD8HR or AD824 head
amplifiers (preamplifiers), or RS-232C compatible controllers. Up to 8 head AD8HR/AD824 head amplifiers
can be connected. Control can be handled either from the Utility display HA page (described on page 54 of
this manual), or from the DME Designer application.
When connecting to a combination of AD8HR and AD824 head amplifiers, be sure to place the AD8HR
units closest to the DME64N/24N in the chain, otherwise the AD8HR unit(s) may not be properly
recognized by the DME64N/24N.
DME64N/24N
AD824
N OT E
Only control signals are transmitted and received via the REMOTE connection. Audio connections must be made separately.
When connecting an RS-232C compatible controller set the Utility display "Misc" page "Remote" parameter
to "COM (RS232C)" – see page 51 of this manual.
34
DME64N/24N Owner's Manual
9-pin D-SUB Cable (Interlink Cross)
REMOTE
AD8HR
COM PC/RS422 COM RS422
AD824
HA REMOTE 1 HA REMOTE 2
AD8HR
COM PC/RS422 COM RS422
HA REMOTE 1 HA REMOTE 2
COM PC/RS422
AD824