Yamaha DME64N Owner's Manual page 21

3.
Install the DME Designer software and necessary drivers on the computer to be used for
zone control.
See the separate "DME Designer Installation Guide" for details.
4.
Connect the device to the computer and/or other equipment.
Refer to "Connection" on page 24 for details.
5.
Turn power to the computer, DME64N/24N, and related devices on. Press the DME64N/24N
[POWER] switch to turn it on.
To prevent the initial power-on surge from generating a large noise spike or damaging your speaker system, turn
devices on in the following order: audio sources, mixer and/or recorders, and finally power amplifiers. Reverse this
CAUTION
order when turning power off.
No information will appear on the display the first time the device is turned on. The appropriate scene and
other data must first be transferred to the device from the DME Designer.
Once the appropriate data has been transferred to the device, the current number and name will appear on the
display:
If any scene data has been stored in the DME64N/24N, the current scene and its name will be displayed.
6.
Set up the DME64N/24N operation parameters.
See the "Utility Display" section on page 47 for details.
N OT E
The "NET" page settings must be set up as required before using the unit for the first time.
7.
Launch the DME Designer application on the computer.
DME Designer setup, operation, and data transfer instructions can be found in the DME Designer Manual.
This completes preparation of the DME64N/24N system.
Setup Procedure
DME64N/24N Owner's Manual
21