Scene Recall; Scene Store - Yamaha DME64N Owner's Manual

Scene Recall

This procedure recalls a new scene (refer to page 14).
NOT E
The same procedure is used for scene recall from an ICP1 control
panel.
1.
Press the [SCENE] button.
The Scene Recall display will appear.
2.
Select a new scene.
Scenes are selected as described in the "List Parameters"
section on page 41.
3.
Press the [ENTER] button.
A confirmation window will appear.
4.
Press the [ENTER] button again.
The new scene will be selected.
NOT E
Scenes can also be changed from a computer or GPI/MIDI
controller connected to the device.
The DME Designer application is used to make scene changes
from a computer. If a GPI/MIDI controller is to be used for
changes it must be initially set up for scene change control by
using the DME Designer.
N OTE
If head amplifier parameters are included in the recalled scene
data, the head amplifier settings will be changed accordingly.

Scene Store

Stores the current scene data for later recall.
N OTE
This function can be accessed in the same way from the ICP1.
1.
Press the [SCENE] button for longer than 2
seconds.
A confirmation window will appear on the display.
2.
Press the [ENTER] button.
This stores the scene data in the current scene memory.
N OTE
Press the [CANCEL] button if you want to abort the scene store
operation.
N OTE
If head amplifier settings are included in the scene the Utility
display HA page settings are also stored. If head amplifier settings
are not included in the scene, the HA page settings are stored as
head amplifier startup settings.
N OTE
Any parameter values changed by GPI/MIDI controllers will be
lost if the power is turned off or if scenes are changed. To preserve
the changed values, store the scene data.
DME64N/24N Owner's Manual
Parameter Edit Displays
43