Security Setup (Lock) Page; Panel Lock Boot; Panel Lock Target - Yamaha DME64N Owner's Manual

Utility Displays

Security Setup (Lock) Page

Panel lock and related settings.
1
2
3
4
1 Utility
The lock status for the Utility display settings. This
parameter can be set to "Unlock" or "Lock."
Unlock: The Utility display can be accessed without a
password.
Lock: A password must be entered to access the Utility
display.
When "Lock" is selected a password entry window will
appear when the [UTILITY] button is pressed to access
the utility pages.
Use the [E ] and [F ] buttons to position the cursor,
and the dial to enter the desired character at the cursor
location. When all of the password's characters have been
entered as required press the [ENTER] button.
The password will also be required when switching from
the "Unlock" mode to the "Lock" mode.
NOT E
Password security and management is very important!
If you forget your password the unit cannot be operated!
If you forget your password contact the system administrator.
If the password become unrecoverable for some reason and you
need to unlock the system, please contact your Yamaha
representative.
50
DME64N/24N Owner's Manual

2 Panel Lock Boot

Determines whether or not panel lock will be on when
power to the device is turned on. This parameter can be set
to "Unlock" or "Lock."
Unlock: Panel lock is OFF when power to the device is
turned on.
Lock: Panel lock is ON when power to the device is
turned on.

3 Panel Lock Target

Determines the controls (control functions) to be affected
by panel lock. The available settings are "Key Only" and
"Key+GPI."
Key Only: Panel lock only affects the panel buttons.
Key+GPI: Panel lock applies to the panel buttons as well
as GPI control input.
N OTE
See page 39 for details on how to use the Panel lock feature.
4 User Defined Lock
Sets the lock status individually for each of the four user-
defined parameter pages.
ON: The corresponding user-defined parameters will not
appear on the display.
OFF: The corresponding user-defined parameters will
appear on the display.
To change the settings use the [E ] and [F ] buttons to
move the cursor to the setting for the desired page, the
press the [ENTER] button to alternately turn the setting
"ON" and "OFF."
N OTE
The user-defined parameters are accessed as described in the
"Parameter Edit Display" section on page 40.