Cascade Setup (Cascad) Page - Yamaha DME64N Owner's Manual

4 Gain
Individually sets the gain of each head amplifier channel.
Edit using the "Numeric Parameters" editing procedure
described on page 40.
NOT E
The gain of the DME24N internal head amplifiers can be
adjusted from +10 dB to –60 dB in 1-dB increments. The
internal circuitry switches at about the –45-dB point, and the
signal is automatically muted at that point to prevent noise.
The AD8HR gain can be adjusted from +10 dB to –62 dB in
1-dB steps, and the AD824 gain can be adjusted from +10 dB to
–62 dB in 6-dB steps.
5 +48V
Individually turns phantom power ON or OFF for each
head amplifier channel.
Use the [E ] and [F ] buttons to position the cursor at
the desired channel, then press the [ENTER] button to
alternately turn phantom power for that channel ON and
OFF.
• Always turn the phantom power off when it is not
needed.
• Phantom power should only be used with phantom-
CAUTION
powered condenser microphones. Turning phantom
power ON when other types of equipment are
connected can result in damage. Balanced dynamic
microphones, however, will not be affected by phantom
power.
• To prevent speaker and possible hearing damage, be sure
to turn power amplifiers OFF when turning phantom
power ON or OFF. It is also a good idea to turn the
output level all the way down (page 42).
6 Phantom Master Switch (AD8HR only)
Displays overall phantom power ON or OFF.
7 High-pass Filter (HPF) (AD8HR only)
Individually turns the high-pass filter for each AD8HR
head amplifier channel ON or OFF. This parameter is only
available for the AD8HR head amplifier. Use the [E ] and
[F ] buttons to select a channel, then press the [ENTER]
key to turn the HPF for that channel ON or OFF.
8 High-pass Filter Frequency (Frq) (AD8HR
only)
Individually sets the high-pass filter frequency for each
AD8HR head amplifier channel. This parameter is only
available for the AD8HR head amplifier.
Edit using the "Numeric Parameters" editing procedure
described on page 40.

Cascade Setup (CASCAD) Page

Determines the operation of the [CASCADE] connectors.
Refer to "CASCADE Connection" on page 32 for
connection details.
N OTE
This page only appears on the DME64N.
1
2
3
1 Head Margin
Shows the status and sets the head margin of the audio
signal handled via the [CASCADE] connectors. The
options are "0dB" and "-18dB."
0dB: The head margin is 0 dB.
-18dB: The head margin is -18 dB.
N OTE
The Head Margin setting only applies when connected to a
mixer. When not connected to a mixer the head margin is
automatically set to 0 dB.
2 Unit No
This parameter specifies how many devices the unit is from
the beginning of the cascade chain.
OUT
IN
PM5D DME64N
Unit No = 01
3 Mixer I/O
Status and setup for the channels to be used for audio
signals cascaded to a mixer.
Edit by moving the cursor to a channel number and
pressing [ENTER] to set as required.
: Channel audio will be transmitted to and received
from mixer.
: Channel audio will be transferred between DME64N/
24N units.
N OTE
Make sure that the Mixer I/O setting is the same for all cascaded
DME64N/24N units.
DME64N/24N Owner's Manual
Utility Displays
OUT IN OUT IN
DME64N DME64N
Unit No = 02 Unit No = 03
55