Monitoring - Yamaha DME64N Owner's Manual

Parameter Edit Displays

Monitoring

The monitor functions allow you to monitor the audio
signal at the inputs or outputs of I/O slots, points between
components, and other critical monitoring points.
NOT E
User-defined monitoring functions, such as monitoring at points
between components, must specified via the DME Designer
application.
NOT E
These functions cannot be accessed from the ICP1.
1.
Press the [MONITOR] button.
The slots available for monitoring will be shown in the
parameter list.
2.
Select the desired monitor source from the list.
List selections are made as described in the "List
Parameters" section on page 41.
When a selection is made the Monitoring Point display
will appear.
3.
Select the desired monitor point from the list.
The audio signal from the selected monitoring point will
be output via the PHONES jack.
NOT E
Press the [CANCEL] button to move back to the previous edit
display.
44
DME64N/24N Owner's Manual
Probe Monitor Functions
The Probe Monitor function allows monitoring points to
be selected from the DME Designer application. Only slot
inputs and outputs and monitoring points previously
specified via the DME Designer application can be selected
from the DME64N/24N control panel, but the "Probe
Monitoring" function allows monitoring points to be
freely selected. Refer to the DME Designer Manual for
details.
N OTE
"Probe" will appear on the DME64N/24N display while the
Probe Monitor function is active.